Lenkungsdämpfer-Halter Schelle 1 1/2" Spurstangen 38,1mm Jeep Wrangler JK, JL, JT Steering Stabilizer Tie Rod Clamp, Zinc Plated

Lenkungsdämpfer-Halter Schelle 1 1/2" Spurstangen 38,1mm Jeep Wrangler JK, JL Jeep Gladiator JT Steering Stabilizer Tie Rod Clamp, Zinc Plated (1-1/2" OD tube) PPM 4050-50 / SYS4050-50

Lieferung:  1 X  PPM-4050-50 / SYN-4050-50

INFO über Produkte:

These CNC machined steering stabilizer clamps are designed to mount any steering stabilizer utilizing a 1/2" mounting bolt to a 1-3/8", 1-1/2", or 1-5/8" diameter tie rod or drag link. These are for steering stabilizers only and are not intended for use with hydro assist.

Fitment:

• Factory Jeep JK Tie Rod (4050-38)
• Synergy Jeep JK Tie Rod OLD 8002 (4050-38)
• Synergy Jeep JK Tie Rod NEW 8002-15 (4050-50)
• Synergy Jeep TJ/XJ/ZJ/MJ Drag Link (4050-38)
• Synergy Jeep JL/JT Tie Rod (4050-50)
• Factory Jeep JL/JT Tie Rod (4050-63)

4050-38:

• CNC machined from 1020 DOM material
• Zinc plated for maximum corrosion resistance
• Designed to mount factory and aftermarket style steering stabilizers utilizing a 1/2" mounting bolt
• 100% bolt on components assures an easy, trouble free installation with the use of basic hand tools

4050-50:

• CNC machined from 1020 DOM material
• Zinc plated for maximum corrosion resistance
• Designed to mount factory and aftermarket style steering stabilizers utilizing a 1/2" mounting bolt and has a 5/8" mounting hole
• 100% bolt on components assures an easy, trouble free installation with the use of basic hand tools

4050-63:

• CNC machined from 1020 DOM material
• Zinc plated for maximum corrosion resistance
• Designed to mount factory and aftermarket style steering stabilizers utilizing a 1/2" mounting bolt
• 100% bolt on components assures an easy, trouble free installation with the use of basic hand tools
• Note: SYN-8003-10 has been superseded to SYN-4050-63

Note:

• Some late model Jeep JK (2011+) factory stabilizers will require the inner bushing sleeve to be drilled out to 1/2" for compatibility. This sleeve is made of hardened steel, so be sure you have the resources to drill it out. Alternatively, an aftermarket stabilizer is recommended.

• Can be retrofit to FOX Through Shaft stabilizers with 1/2" x 20 countersunk bolt.